How to Install a Wiremold Box
- 1). Turn off the circuit breaker to any wiring inside the raceway where you will be working.
- 2). Snap off the removable plastic pieces on the back of the Wiremold device box. Use the pliers to twist off the plastic pieces.
- 3). Install the mounting bracket from the device box to the raceway. The device box will bring all the materials needed to secure the device box to the raceway, including the mounting bracket. Push the mounting bracket to the raceway where you want to install the device box and secure it by installing the screws to the wall using the drill.
- 4). Pull out the wiring through the center of the mounting bracket. If you cannot pull out the wiring with your fingers, use the pliers to pull it out.
- 5). Push the device box to the mounting bracket so it is flush with the raceway. Secure the device box to the mounting bracket using the screwdriver. The device box is now installed and is ready to accept any electrical device to be attached to it.