How to Install the Wiper Motor's Pulse Module on a 1996 Chevy S-10
- 1). Remove the negative cable from the S-10's battery.
- 2). Pull the wiper arms off the arm linkage by pressing down on the release tab.
- 3). Remove the cowl grille and loosen the two nuts on the motor crank arm.
- 4). Disconnect the electrical connector from the wiper motor.
- 5). Remove the two wiper motor/cowl screws. Pull the motor off the vehicle.
- 6). Remove the three Torx screws connecting the pulse module to the motor. Remove the pulse module and replace it with a new one. Reinstall the three screws and reattach the motor to the vehicle.
- 7). Reconnect the electrical connector to the wiper motor and reinstall the two screws.
- 8). Tighten the two motor crank arm nuts and reattach the cowl grille and wiper arms. Reconnect the battery.