Front door speakers

• 1). Pry around the edges of the sail panel at the front edge of the window with a panel tool and remove the panel when it's loose.
  
  
• 2). Pry around the edge of the door pull handle, starting at the bottom front edge. Take out the two T25 Torx screws underneath the handle.
  
  
• 3). Go around the edge of the door and remove eight retaining clips. Push in on the center pins of the clips and then pry around the edges to remove.
  
  
• 4). Lift the door panel up and unplug the wiring harnesses on the back. Set the panel aside.
  
  
• 5). Remove the four T20 Torx screws holding the speaker in place, pull the speaker out and unplug the wiring harness.
  
  
• 6). Plug the new speaker in, screw it in place in the door and reassemble the door panel.
  
  

Rear door

• 1). Pry out the square plastic screw cover on the inside of the door pull. Take out the T25 Torx screw underneath the cover.
  
  
• 2). Remove the retaining clips around the outer edge of the door panel.
  
  
• 3). Lift the door panel up, unplug any wiring harnesses connected to the back and set the panel aside.
  
  
• 4). Drill out the rivets holding the factory speaker in place. Pull out the old speaker and unplug it.
  
  
• 5). Plug in the new speaker and screw it into place, using the holes as pilots for the new speaker's mounting tabs.