How do I Install a Jeep Wrangler Hardtop Sunroof?
- 1). Turn your Wrangler's engine off and disconnect its negative battery cable.
- 2). Open the Wrangler's tailgate in the rear and make sure the window on the hardtop is closed.
- 3). Set the back piece of the hardtop onto the rails on the side of the Jeep Wrangler and test closing the tailgate to make sure it closes properly.
- 4). Place the 5/18 bolts inside their washers and insert them into the bolt holes on the inside of the hardtop. There are three on each side.
- 5). Place the tapping plate underneath each bolt as they exit the drill holes and tighten the bolts with the Phillips head screwdriver.
- 6). Place the front part of the hardtop onto the top rails of the Jeep Wrangler. Hook the latches from the inside of the Wrangler up and they will connect to the front part of the hardtop.
- 7). Install the weatherstrip onto the bottom edge of the rear of the hardtop where the tailgate touches the hardtop. Reconnect the negative battery cable.