How to Install a Beaks Bar on a DC2R
- 1). Raise the back end of your car using the jack. For safety purposes, be sure to consult your owner's manual to find the correct factory recommended jacking points.
- 2). Find the control arms for your car's chassis. These are on either side of the axle. Remove the pivot bolts that connect these to the chassis.
- 3). Attach the Beaks tie bar brackets to the control arms using the bolts you removed. Do not tighten fully.
- 4). Align the Beaks tie bar on the brackets and insert the included bolts to hold it in place. Once the bar is flush, tighten all bolts.