How to Make Lara Croft Leg Holsters
- 1). Cut two strips of hard cardboard, both one-and-a-half inches wide, one that is one foot long and one that is six inches long. Cut another small piece of cardboard that will fit between the two sides of the holsters, about one inch by one-and-a-half inches.
- 2). Cover the three cardboard pieces in black duct tape.
- 3). Place hot glue from a glue gun on the edges of the one inch by one-and-a-half inch piece of cardboard. Place the small edge of the one-and-a-half-inch-wide pieces on the glue and hold them in place. Wait a few minutes and then place the pieces up against the wall to give the glue a chance to dry. Wait a few hours to resume work.
- 4). Place the fake gun in between the two longer pieces of cardboard. Wrap the Velcro strip around the middle of the two pieces of cardboard and the gun. Tighten the strip until it is tight enough for the gun to fit snugly and loose enough to take the gun out. Wrap the piece of Velcro in the black duct tape if desired.
- 5). Attach the longer piece of cardboard to the side of the belt using the black duct tape so that the longer piece of cardboard will sit flush against your hip. Repeat steps 1 through 5 to create another holster to go on your other hip.