Instructions for How to Assemble a Teen's Trend Loft Bed
- 1). Open the package and thoroughly inspect the contents. Consult the parts list to make sure that all necessary parts are present. Set small bags of parts on a tray or within an empty toolbox of some kind to prevent them from getting lost or mixed up with other parts. Contact the manufacturer or the retailer to obtain additional parts if required.
- 2). Read the included instructions completely from beginning to end, paying particular attention to any warnings, tips or notices that may present information specific to your loft bed..
- 3). Assemble each end of the bed first, by putting the bedposts and the bedpost supports together and attaching them with the included Allen wrench or a screwdriver. Attach each piece of the two bed ends tightly, and then stand them up against the wall.
- 4). Set the various parts of the mattress support together, tightening each shorter mattress support board into the longer boards which span between the two bed ends. Complete this installation, unless it is recommended that these parts be completed after the ends have been attached together, in which case wait until a later time.
- 5). Keep one bed end against the wall with its attachment openings facing outward and have an assistant hold the other end away from the wall, parallel to the wall end and facing it with its attachment openings. Lift the assembled mattress support section up against the two end frames. Attach the mattress support to each end with the included hardware.
- 6). Attach any guardrails or additional pieces at this point, including any ladders or additional supports. Re-tighten all attachments throughout the loft, revisiting even the first attachment points. Set the mattress on top of the loft to ensure a good fit.