Remove the Power Nozzle

• 1). Press down the large pedal on the rear right of the unit to raise it up.
  
  
• 2). Lift the Headlight Hood, pull out the handle on the nozzle and turn it clockwise (toward the green arrows) until the red arrows are lined up. This disengages the belt and brush.
  
  
• 3). Turn the Accessory Lock to the left and remove the nozzle.
  
  

Attach and Use the Zippbrush

• 1). Connect the Attachment Hose in the same place where you just removed the Power Nozzle. To do this, fit the hooks of the hose connector over the bar where it connects to the unit.
  
  
• 2). Turn the Accessory Lock back to the right to lock the hose in place.
  
  
• 3). Attach one or two Extension Tubes to the end of the hose to extend your reach, for instance if you will be vacuuming a large piece of furniture.
  
  
• 4). Place the Zippbrush securely on the end of the hose or tube.
  
  
• 5). Turn on the Kirby unit and vacuum stairs, upholstery or other surfaces. The spinning of the brush provides the best cleaning. Don't press so hard that the brush cannot spin.
  
  

Cleaning Up

• 1). Remove the Kirby Zippbrush from the tube or hose.
  
  
• 2). Press the button on the front of the brush, without putting pressure on the outer ring brush. This releases the ring.
  
  
• 3). Lift the central portion of the brush out and remove any lint, hair, fur or debris from all the pieces.
  
  
• 4). Reassemble the Zippbrush by reversing the first two steps in this section.