Preparing the Area Rug

• 1). Move all toys or furniture off the rug. Enlist the assistance of a friend or family member to help move large pieces of furniture.
  
  
• 2). Roll the rug up by starting at one end. Have a friend help move the rug into a less trafficked area. This will allow the rug to dry without gaining new stains. Be sure the new area is clean. Lay the rug out again.
  
  
• 3). Vacuum the loose debris and pet hair. Run the vacuum over the area rug until the specks of debris are gone.
  
  

Manual Cleaning

• 1). Purchase a manual carpet cleaning solution. You can choose OxiClean Revitalizer Carpet Cleaning Solution or Zep Speriror Solutions High Traffic Carpet Cleaner. These are obtainable in regular supermarkets or department stores in your area. You can choose another hand-carpet cleaning solution as well.
  
  
• 2). Gather your supplies and take them to the area rug. This includes a pan of hot water, your cleaning solution, the brush and rag.
  
  
• 3). Spray your solution in a row at the top of the rug. Mist the entire area evenly. One or two squirts are efficient since the solution goes a long way.
  
  
• 4). Use your soft bristle brush to rub the solution in the carpet. Employ a circular motion for a deep down clean. Cover the entire area where you sprayed.
  
  
• 5). Dip the rag into the hot water. Wring it out completely. Wipe the area in a straight line. Squeeze the soap and dirt out frequently.
  
  
• 6). Repeat Steps 3 to 5 to clean the whole area rug.
  
  

Carpet Cleaner

• 1). Purchase or rent a carpet cleaner. You can usually rent a cleaner at a local department store for approximately $20 a day, plus the cost of cleaning solution. Purchasing a carpet cleaner can cost roughly $50 to $400.
  
  
• 2). Take the water and soap holder off the carpet cleaner. Typically, this just lifts off. Read the holder. Usually, there is a water line and soap line. Fill the water to the line then add soap.
  
  
• 3). Replace the holder onto the carpet cleaner. Normally, the holder snaps into place.
  
  
• 4). Take the carpet cleaner to the area rug. Plug it in and push the "On" button.
  
  
• 5). Use the cleaner over the area rug in rows. Usually, there is a trigger or button to release the water/soap solution. Push the machine forward, holding the trigger. Release the button and pull the machine back. Complete this twice for each row of the area rug.