How to Replace Brake Pads in a Buick Rendezvous
- 1). Loosen, but do not remove, the lug nuts on your wheel. Place the jack under the frame of your vehicle's front or rear end depending on which end you are working on. Jack up the Buick enough so your tires are off the ground. Slide the jack stands under each side behind the wheel to support the car if your jack happens to fail.
- 2). Remove the lug nuts and pull the tire off. Locate the caliper, brake pad, and rotor. Remove the calipers from the brake pad using the wrench. Set them down gently since they are still connected to the brake lines to avoid damage.
- 3). Put on the mask and gloves to avoid exposure to the brake pad dust. Gently remove the brake pads. Apply the C-clamp to the brake piston. This will reset the brakes. Put the new brake pads on and reconnect the caliper to the new pads. Remove the C-clamp.
- 4). Slide the wheel back on the axle. Replace the lug nuts. Fully tighten the lug nuts with the lug nut wrench after you have replaced the opposite side's brake pads and lowered the car.