Removing Safety Tags
- 1). Cut the tag off with scissors if it is attached with thread or sewn into a hemline. Stores may place a security tag on the label of the item, therefore it can be removed simply by cutting the label out of the item.
- 2). Remove any cardboard that may be inserted into an ink-release tag. These tags are notorious for spitting ink onto the clothing if someone attempts to open the security tag. There are ways to open the tag without activating the ink.
- 3). Wipe the thin wire cutters off with a clean rag to remove any oil or grime. The wire cutters should be small and thin with a long nose. Because the cutters will be inserted into the space between the ink and pin, the cutters will rub against the clothing and may make a mark or stain.
- 4). Insert the wire cutters into the space between the clothing and the smaller side of the security tag. The larger side of the tag typically contains the ink; therefore work from the other side.
- 5). Wiggle the wire cutters inward until you hit the metal pin. Gently squeeze the wire cutters until the pin pops. Do not try to turn the wire cutters to widen the gap -- this will break the seal and cause the ink to explode. If you are unable to reach the metal pin with the wire cutters, then remove the cutters and use the thin saw. The saw should slide easily between the fabric and pin head. However, use caution when sliding the saw on the fabric because it may snag.
- 6). Cut the pin and remove the tag. Discard both pieces immediately to prevent an unwanted ink explosion.