Assembly

• 1). Saw one end of each of the 33" boards into a point with an angle of approximately 110 degrees. Each of the angled edges should be approximately 6 1/2" in length.
  
  
• 2). Nail the 25 1/2 inch board between the two 33" boards perpendicular to them. This board should be placed 5 1/2 inches from the ground.
  
  
• 3). Beginning 1" from the point of the upright 33" boards, nail two of the 1 by 2 1/2' boards on each side of the point. Leave approximatly 1" between them. There should also be a slight overhang on both the front and the back.
  
  
• 4). Sand until the boards are smooth.
  
  
• 5). Stain or varnish to taste.