How to Make a Halloween Wreath From Styrofoam
- 1). Purchase a Styrofoam ring from a craft store to act as the base of the wreath. If you want to work with a block of Styrofoam you already have, use a sharp craft knife to cut out a ring yourself. The ring should be about 1 foot in diameter.
- 2). Lay the ring on a sheet of newspaper and paint it orange using a can of spray paint.
- 3). Heat up a hot glue gun and begin attaching each piece of candy to the ring, one at a time, attaching the body of the candy flat to the Styrofoam. Glue the pieces close together so that virtually none of the Styrofoam shows through. Continue until the whole ring is covered, then let dry.
- 4). Tie a piece of black satin ribbon in a bow and glue it to the bottom of the wreath to finish it off.