How to Replace the GE Triton Profile Dishwasher Upper Arm
- 1). Turn off the breaker or remove the fuse connected to the power outlet where the dishwasher is plugged in.
- 2). Open the door. Slide the bottom rack out as far as it will go. Lift the rack out of the GE Triton Profile.
- 3). Insert the tip of the flat-blade screwdriver along the seam of the hub cap on the spray arm. Twist the screwdriver to pry the hub cap off.
- 4). Use a wrench to remove the bolt that was covered by the hub cap.
- 5). Pull the spray arm off the hub.
- 6). Position the new upper spray arm onto the arm hub. Install the bolt that holds it in place.
- 7). Replace the hub cap over the bolt connection. Press down until it clicks into place.