Software and EFI Map Setup

• 1). Install the race tuner software on your computer.
  
  
• 2). Modify your fuel-injection map and settings as desired using the race tuner software.
  
  
• 3). Connect the included 9-pin serial cable (note that newer kits may replace the serial cable with a USB cable that terminates into a female 9-pin connector) to the computer.
  
  

Modifying the ECM

• 1). Turn the motorcycle's ignition switch to the "Off" position.
  
  
• 2). Remove the right side cover (or seat cover, depending on the model) to access the motorcycle's data link connector.
  
  
• 3). Connect the 4-pin connector end of the cable included with the kit to the motorcycle's data link connector. Carefully tighten the thumbscrews.
  
  
• 4). Connect the Race Tuner's interface module to the 9-pin female end of the motorcycle's cable. Carefully tighten the thumbscrews.
  
  
• 5). Connect the 9-pin female connector from the computer into the 9-pin male end of the race tuner's interface module. Carefully tighten the thumbscrews.
  
  
• 6). Turn the ignition switch to the "On" position and wait for the motorcycle to run through its 10-second startup process.
  
  
• 7). Select your modified EFI map, using the race tuner software, and click on "Program ECM."
  
  
• 8). Allow the software to reprogram your motorcycle's ECM without interruption. This process can take as long as five minutes, depending on your computer's processor speed.
  
  
• 9). Turn the ignition switch to the Off position once programming is completed.
  
  
• 10
  
  Disconnect the race tuner's interface module and cables from the motorcycle.
  
  
• 11
  
  Turn the ignition switch to the On position and wait for the motorcycle to run through its 10-second startup process.
  
  
• 12
  
  Start your motorcycle and test to see whether the modified EFI map has the desired effect. If not, modify the EFI map using the software and reprogram as shown previously.