How to Put on Mora Ice Auger Blades
- 1). Unscrew the two screws holding the dull blade with a 1/8-inch Allen wrench. Be very careful, so you don't cut yourself. Note the position the blades are facing for re-installation.
- 2). Repeat the process for the second blade.
- 3). Position a sharp blade on the bottom of the auger. The flat side (with the stamped writing) should face down, toward the ice. The beveled edge should face up. Also, the wide edge should be on the outside, with the narrow edge on the inside.
- 4). Install the two screws into their holes from the top. Installing them from the bottom would prevent the blade from cutting ice.
- 5). Tighten with the 1/8-inch Allen wrench.
- 6). Repeat the process for the second blade.