Resetting the Time

• 1). Access the program to set the time by pushing the time button. The time button is the far left button on the right side of the Sunbeam display and looks like a little clock. The digits on the display will start flashing.
  
  
• 2). Press the adjust button to change the hour. The adjust button is the middle button on the right side of the water cooler display panel. The button has an exclamation mark on it. Continue pressing the adjust button until the correct hour has been reached.
  
  
• 3). Push the time button to change the program from setting the hours to setting the minutes. The minute digits will flash when this is accomplished. Use the adjust button again to set the appropriate minutes. Repeat this step to set the seconds if so desired as well.
  
  
• 4). Push the time button one time after the time has been set to start the Sunbeam water cooler clock working.
  
  

Resetting Water Temperature

• 1). Push the temperature button that is on the far right side of the Sunbeam water cooler console. The digital display will show the current temperature of the cold and hot water in Fahrenheit. Press it twice to be able to reset the set temperatures for the hot and cold water.
  
  
• 2). Hold down the adjust button to adjust the temperature of the cold water. This is the first temperature that is displayed when the temperature button is pressed. Press the temperature button again when the desired temperature is set.
  
  
• 3). Press the clock button to exit the programming portion of the Sunbeam display and return to showing the time.